No matter you are relaxed, transitioning or natural, you will find a suitable texture on here at hair control.
normally one bundle is enough to cover full head. (but if you want fuller please order 2 )
Clip-in hair extensions are for  the person who want to to add some extra length and fullness on your hair within minutes . Also clip ins can be used as a protective style during your transition to natural hair. clips ins are very easy to install (hassle free )  

                                  '  How to Apply Clip-in Hair Extensions '


STEP ONE: SEPARATE YOUR HAIR Starting at the lower back section of your head, use a tail comb or index finger to divide (horizontally part) your hair, at the lower back of the head. For example just below one ear to the second ear. Also, you can start parting even lower, as low as you want to place the first weft.


STEP TWO - SECTION YOUR HAIR Clip in Hair Extensions should be attached from the bottom up. Starting at the lowest point on the hairline, and using a tail comb or your index fingers, create a part where you wish to section off the hair.


STEP THREE - CLIP UP YOUR HAIR Clip your remaining hair, firmly on the top of your head, to keep it out of the way as you fit the wefts.


STEP FOUR - PREPARE THE FIRST WEFT Take the first weft from your Clip in Hair Extensions Set. Then open all the clips so they are ready to be inserted into your hair.


STEP FIVE - PLACEMENT OF THE FIRST WEFT Insert the opened centre clip just below the parting. Insert the snap clip on your hair not on the raw scalp. Snap the clip shut, so it grips your hair. Repeat with the remaining clips.


STEP SIX - CREATE A NEW PARTING Release the hair you held out of the way and create a new parting. To do this, comb down a layer of hair, with about half an inch or so between each weft layer. Each time secure the extra hair, on top of your head.


STEP SEVEN - PLACEMENT OF THE REMAINING WEFTS Now insert the remaining wefts in the same manner as above. Repeat the process with a new parting above each weft extension.


STEP EIGHT - CHECK FOR GAPS Now that the Clip in Hair Extensions are attached, run your fingers along the weft to make sure it lies flat against your head along the entire width. If there are any gaps, correct this by snapping the clip open, lifting it off hair and repositioning it so that the weft lies flat.


STEP NINE - REMOVING THE HAIR WEFTSTo remove Clip in Hair Extensions, snap open all the clips and gently lift up and away from your hair. Never try to remove a weft without first opening all the clips. BACK

Clip ins

choose you length